![]() ![]() ![]() ![]() Depending on the image size and options chosen, this may take from a few seconds to a few minutes. Verify all the settings in the right-hand column, then press OK to create the gcode. Start image-to-gcode either by opening an image file in AXIS, or by invoking image-to-gcode from the terminal, as follows: The standard sim/axis.ini configuration file is already configured this way. ini file to make AXIS automatically invoke image-to-gcode when you open a. 1.2 Integrating image-to-gcode with the AXIS user interfaceĪdd the following lines to the section of your. Roughing offset and depth per passĪ depth map is a greyscale image where the brightness of each pixel corresponds to the depth (or height) of the object at each point. Integrating image-to-gcode with the AXIS user interface ![]()
0 Comments
Leave a Reply. |